Tel: +44 (0)1405 861800

HV007

HV007 AB Medium High Port Kimblewick Short Cheek (Dalehead)

HV007 AB Medium High Port Kimblewick Short Cheek (Dalehead)

Additional information

Mouthpiece Width

, , , ,

Mouthpiece Thickness

Mouthpiece Material

£84.00

  • 5inch / 125mm
  • 5.25inch / 135mm
  • 5.5inch / 140mm
  • 5.75inch / 145mm
  • 6inch / 150mm
Clear
30daytrial

CLICK HERE

For more information on how the trial system works

Description

AB Medium High Port Kimblewick Short Cheek

 

The bar of the mouthpiece is attached to the cheek of the
bit using a C sleeve design, to allow the cheek piece to slide a little
without pinching the corners of the horse’s lips; it can swivel freely
sideways, but only moves up and down within a short range. There is a
loop at the top of the Bit for the leather cheek piece of the bridle,
and it has three rein options.

As you attach the cheek piece of your bridle into the top slot of
the bit ring, this sits the bit up in the horse’s mouth and stabilises
it, taking some of the weight off the horse’s tongue.  The top rein option on the bit ring
itself just pulls the mouthpiece back in the mouth, without bringing any
leverage to bear. If you choose to put the rein down into the bottom
slot of the bit ring, you get a more defined signal, and a little poll
pressure; the mouthpiece rotates down into the mouth to give a clear
signal to the horse to yield to the action. The middle rein option,
where the rein sits in between the loops, brings a little more leverage
to bear than the top ring option.

 

A curb chain or strap must be used with the kimblewick to distribute
even pressure on the horse’s jaw, which will help stabilise the bit and
prevent it rotating too far downwards into the mouth.

Additional information

Mouthpiece Width

, , , ,

Mouthpiece Thickness

Mouthpiece Material

preloader